Haas Mill G153 5-Axis High Speed Peck Drilling Canned Cycle

Haas G Codes Mill Reference

G153 5-Axis High Speed Peck Drilling Canned Cycle (Group 09)

E Specifies the distance from the start position to the bottom of the hole
F Feedrate in inches (mm) per minute
I Size of first cutting depth (must be a positive value)
J Amount to reduce cutting depth each pass (must be a positive value)
K Minimum depth of cut (must be a positive value)
L Number of repeats
P Pause at end of last peck, in seconds
Q The cut-in value (must be a positive value)
A A-axis tool starting position
B B-axis tool starting position
X X-axis tool starting position
Y Y-axis tool starting position
Z Z-axis tool starting position

1
This is a high-speed peck cycle where the retract distance is set by Setting 22. If I, J, and K are specified, a different operating mode is selected. The first pass will cut in by amount I, each succeeding cut will be reduced by amount J, and the minimum cutting depth is K. If P is used, the tool will pause at the bottom of the hole for that amount of time. Note that the same dwell time applies to all subsequent blocks that do not specify a dwell time.


G153 5-Axis High Speed Peck Drilling Canned Cycle