Haas Mill G87 Bore In and Manual Retract Canned Cycle

Haas G Codes Mill Reference

G87 Bore In and Manual Retract Canned Cycle (Group 09)

F Feedrate in inches (or mm) per minute
L Number of holes if G91 (Incremental Mode) is used
R Position of the R plane (position above the part)
X X-axis location of hole
Y Y-axis location of hole
Z Position of the Z-axis at the bottom of hole

This G code will stop the spindle at the bottom of the hole. At this point the tool is manually jogged out of the hole. The program will continue when Cycle Start is pressed.
1


G87 Bore In and Manual Retract Canned Cycle