Haas Mill G88 Bore In, Dwell, Manual Retract Canned Cycle

Haas G Codes Mill Reference

G88 Bore In, Dwell, Manual Retract Canned Cycle (Group 09)

F Feedrate in inches (or mm) per minute
L Number of holes if G91 (Incremental Mode) is used
P The dwell time at the bottom of the hole
R Position of the R plane (position above the part)
X X-axis location of hole
Y Y-axis location of hole
Z Position of the Z-axis at the bottom of hole

This G code will stop the tool at the bottom of the hole, and dwell with the ool turning for the time designated with the P value. At this point the tool is manually jogged out of the hole. The program will continue when Cycle Start is pressed.

1


G88 Bore In, Dwell, Manual Retract Canned Cycle