Sinumerik 808D G Codes Mill Quiz

G00 Rapid traverse
G01 Linear movement
G02 Circle/helix in clockwise direction
G03 Circle/helix in the counterclockwise direction
G04 Dwell time in [s] or spindle revolutions
G05 High-speed cycle cutting
G05.1 High-speed cycle -> Call CYCLE305
G08 Pre-control ON/OFFG15 Polar coordinates off
G09 Exact stop
G10 Write work offset/tool offset
G10.6 Retraction from contour (POLF)
G11 End parameter entry
G16 Polar coordinates on
G17 XY plane
G18 ZX plane
G19 YZ plane
G20 Inch input system
G21 Metric input system
G27 Checking the reference position
G28 1. Approaching a reference point
G30 2./3./4. Approaching a reference point
G30.1 Reference point position
G31 Measuring with “delete distance-to-go”
G40 Deselection of cutter radius compensation
G41 Compensation left of contour
G42 Compensation to right of contour
G43 Positive tool length compensation on
G44 Negative tool length compensation on
G49 Tool length compensation off
G50 Scaling off
G51 Scaling on
G50.1 Mirroring on programmed axis OFF
G51.1 Mirroring on programmed axis ON
G52 programmable work offset
G53 Approach position in machine coordinate system
G54 P0 external work offset
G54 Selecting work offset
G55 Selecting work offset
G56 Selecting work offset
G57 Selecting work offset
G58 Selecting work offset
G59 Selecting work offset
G60 directed positioning
G61 Exact stop modal
G63 Tapping mode
G64 Continuous-path modeG66 Macro module call
G65 Macro call
G67 Delete macro module call
G68 Rotation ON, 2D/3D
G69 Rotation OFF
G72.1 Contour repetition with rotation
G72.2 Linear contour repetition
G73 High-speed deep hole drilling cycle with chip breakage
G74 Left tapping cycle
G76 Fine drill cycle
G80 Cycle off
G81 Drilling cycle counterboring
G82 Countersink drilling cycle
G83 Deep hole drilling cycle with chip removal
G84 Right tapping cycle
G85 Boring cycle, retraction with G01 after reaching the end in axis Z, without spindle stop
G86 Boring cycle, spindle stops and then retraction with G00 after reaching the end in axis Z
G87 Reverse countersinking
G89 Boring cycle, stay for a while and then retraction with G01, without spindle rotation direction change
G90 Absolute programming
G91 Incremental programming
G92 Setting actual value
G92.1 Delete actual value, reset the WKS
G93 inverse-time feedrate (1/min)
G94 Feedrate in [mm/min, inch/min]
G95 Revolutional feedrate in [mm/rev, inch/rev]
G96 constant cutting rate on
G97 constant cutting rate off
G98 Return to starting point in fixed cycles
G99 Return to point R in fixed cycles
G290 Selection of Siemens mode
G291 Selection of ISO dialect mode