More G0 Rapid Positioning

RS274/NGC G-code Reference

G0 Rapid Positioning / Rapid Linear Motion — G0
For rapid linear motion, program

G0 X… Y… Z… A… B… C…,

where all the axis words are optional, except that at least one must be used. The G0 is optional if the current motion mode is G0. G0 Rapid Positioning will produce coordinated linear motion to the destination point at the current traverse rate (or slower if the machine will not go that fast). It is expected that cutting will not take place when a G0 command is executing.
It is an error if:
• all axis words are omitted.
If cutter radius compensation is active, the motion will differ from the above. If G53 is programmed on the same line, the motion will also differ.


G0 Rapid Positioning