More G53 Move in Absolute Coordinates

RS274/NGC G-code Reference

Move in Absolute Coordinates — G53

For linear motion to a point expressed in absolute coordinates, program

G1 G53 X… Y… Z…A… B… C…

(or use G0 instead of G1), where all the axis words are optional, except that at least one must be used. The G0 or G1 is optional if it is the current motion mode. G53 is not modal and must be programmed on each line on which it is intended to be active. This will produce coordinated linear motion to the programmed point. If G1 is active, the speed of motion is the current feed rate (or slower if the machine will not go that fast). If G0 is active, the speed of motion is the current traverse rate (or slower if the machine will not go that fast).
It is an error if:
• G53 is used without G0 or G1 being active,
• G53 is used while cutter radius compensation is on.


G53 Move in Absolute Coordinates